|
|
|
|
|
Super Tech & Associates Main Web Home Page w-frames
http://www.super-tech.com/ Le caratteristiche tecniche qui riportate sono state importate dall'indirizzo sopra indicato SuperCam Specifications Host Operating System: MS-DOS or Windows 95 or 98 Release Medium : 3.5" Floppy Diskette Maximum Steps Per Second: 30,000 SuperCam Hardware System Requirements Host Operating System: MS-DOS or Windows 95 or 98 Processor : 486 DX or Better Currently Pentium III 400 Mhz is the development system Processor Clock Frequency : 100 Mhz or Better Math Co-Processor : Required Minimum System RAM: 8 megabytes Display Adapter : 640 X 480 pixels, 16 colors System Pointer : PS2 Mouse or Serial Mouse Floppy Drive: 3.5 inch, 1.44 megabyte Hard Drive: Required Parallel Ports : Standard Parallel Port (SPP) ECP Parallel Ports Do Not Work Prezzo 465 $ |
|
|
Master 5 Master5 strives to conform as closely as possible to Real-Time performance under windows. It provide many features only found on high end hardware controlled software. It is designed for the home hobbiest to provide an inexpensive software only solution to mechanical movement needs. Keyboard Jog NIST274 G-Code for virtually all G/M Codes Control Flood, mist , router, spindle Auto Power off at end of program 4 - axis jogging 4-axis G-Code control HPGL imports DXF Arc,Line,Polyline imports Material Selection Ramp Type selection optimised for different machining job types 3-d rotatable graphics display of toolpath Real-time display of cutter location in toolpath graphics Limit switch referencing Time simulation to check speed of selected parameters Helical milling MM's,Inches and centimeter selections Single step through program. English translation of ToolPath Scaleing of job, HPGL input for laser table. DXF toolpath optimization. Laser control for DXF input. FeedRate OverRide. JPG and BMP photo import for engraving and G-Code output of photographs. Prezzo 75 $ |
|
|
http://www.kellyware.com/ KCam 3 Router/Mill software is designed to run low cost hobby CNC equipment. Program your paths using the built in Gcode editor, or import DXF, NC, and PLT files. Create signs and plates using your CAD software and import your work into KCam. Dual cutting depth allows for holes and outlines to be punched out after routing. No more drilling holes for switches or cutting plates to size before engraving. Engrave signs, make name tags, drill printed circuit boards, mill parts, plasma cuts, plot pictures onto paper... Here are a few of the key features: Load GM code files Import Excellon ASCII drill files(.NC) Import DXF files(.DXF) Import HPGL files(.PLT) Import Gerber files(.GB0) Edit/Write GM code files 3D Graphical Viewer w/ Zoom,Pan and Table Views Manual Jogging motor control Controller and Table setup features Supports Parallel Port (LPT) Stepper Motor Controllers Selectable Feed Rate Backlash Compensation Windows 95/98/NT/2000 32bit Software PCB Isolation conversion from Gerber(RS274X) files Prezzo 95 $ |